Products
Downloads
About
Guest
Products
Downloads
About
TxRail-USB
DIN Rail Temperature Transmitter
Add to Wishlist
Share
Buy Online from our Distributor
Click and drag to rotate
The TxRail-USB is a DIN rail mounted temperature transmitter, which can be configured to provide either loop powered 4-20mA or 0-10Vdc output. USB configuration via the free TxConfig II software and a standard micro-B USB cable allows for selection of input type, measurement range, output type and calibration.

The TxRail-USB accepts thermocouple J, K, T, R, S, N, E, B, Pt100, Pt1000, NTC and 0-50mV input, typically to around 0.1% accuracy (or 0.3°C for NTC input).

A 10 to 35Vdc power supply is required for 4-20mA output, or 12 to 35Vdc supply for 0-10Vdc output. When configured, the unit is powered from the USB, allowing you to easily configure the unit before installing it into a system.
Specifications
Input
Channels
1
Analogue
0 to 50mVdc, impedance >> 1MΩ
Ntc
NTC Sensor, 10kΩ ±1%
Rtd
Pt100 (2/3 wire), Pt1000 (2/3 wire), 0.8mA excitation
Thermocouples
Type J, K, R, S, T, N, E, B
Output
Analogue
4-20mA or 0-10Vdc
Resolution
2µA (4-20mA) or 0.0025V 12-bits (0-10Vdc)
Power
Power Supply
10 to 35Vdc (4-20mA out) or 12 to 35Vdc (0-10Vdc out)
Isolation
No electrical isolation between input and output
Measurement
Range
See datasheet
Accuracy
(Typical) 0.1%, 0.13% for Pt100/Pt1000 between -200 and 650°C, 0.3°C for NTC
Warm Up Time
< 2.5s switch on delay, accuracy guaranteed after 15 minutes
Response Time
typically 1.6s
Interface
Configuration
Via USB and TxConfig II software
Connections
terminal screws on top, 0.8Nm screw tightening
Build
Dimensions
14 x 12.5 x 99.5mm
Weight
200g
Mounting
DIN rail mounted
Material
ABS UL94-HB
Environment
Operating Temperature
-40 to +85°C
Relative Humidity
0 to 90%
Standards
EMC
EN 61326-1:2006
Downloads
Accessories
Related Products
Enquire about the TxRail-USB
Previous
Next
Query has been sent
Query failed to send.
Try again